New Versions for Expert Moldbase Extension 2027.2.1.1, 19.4.3.1, 18.4.7.0, 17.0.10.0 and 16.0.12.1 available!

The new Versions for Expert Moldbase Extension are out now! The Update provides an assamble of new Enhancements such as:

• New “Apply bore depth rule (T5 overbore)” checkbox to apply additional bore depth value T5 on fluid components more flexibly
• In case an additional bore depth rule is defined in EMX Config Options, a new check box becomes visible!

• Only in case the check box is selected the bore depth rule is applied to the T5 – AUTO_DEPTH dimension

• Improve capabilities to suppress/resume subcomponents of assemblies in Component & Library Component Dialog
  • Subcomponents can be suppressed and resumed by variable options.
  • Subcomponent suppression is now displayed in option menu in Library Component Dialog.

→ Can be configured in the Component Editon

• Define Option(→)
• Assign it in  subcomponent table (↓)

• Improve capabilities to suppress/resume subcomponents of assemblies in Component & Library Component Dialog
• Rule-based suppression is visible in subcomponent option menu in Component Dialog
• Library Component Dialog: For Library components, only “Create Pattern” was possible but not “Pattern for all model”.

→ Implement equal behavior like Component Dialog

Improve Option USE_LAYER_FOR_SIDE_VIEWS behavior

→ It is possible to set EMX components now on both, Layer and Simprep, at the same time

• New config option CONFIG_SIDE_VIEW_DISPLAY_MODE with selectable values SIMREP | LAYER | BOTH
• Old option USE_LAYER_FOR_SIDE_VIEWS is deprecated and automatically converted